How To Repair A Leaking Shower Valve Ask This Old House Youtube In this video, when a shower valve in a perfectly preserved original bathroom started leaking, a homeowner reached out to richard trethewey for help fixing i. On the inside of the shower, replace the spindle and tighten it in place. slide the cap over the spindle and tighten it. then, place the new cover plate over the shower valve, line up the diverter valve, and tighten it in place with the supplied screws. install the handle. turn the water back on and check for leaks.
How To Replace A Clogged Shower Valve Ask This Old House Youtube Ask this old house plumbing and heating expert richard trethewey repairs and replaces a leaking shower valve.subscribe to this old house: bit.ly subsc. This old house plumbing and heating expert richard trethewey and tile expert joe ferrante team up to repair a leaky shower valve installation. (see below for. Steps for 3 handle shower faucet replacement. shut off the water at the main water shutoff. put a drop cloth in the tub to protect it from any work and also to prevent small parts from falling down the drain. remove the handles from the valves using the screwdriver. they’re usually under small covers that read “hot” and “cold.”. Clean the valve body thoroughly, removing any debris or old sealant. apply a small amount of plumber’s grease to the o rings on the new cartridge. align the cartridge properly. the hot and cold sides should match the valve body. insert the new cartridge into the valve body, pressing firmly but gently.
First Class Tips About How To Repair Leaking Shower Valve Yardminister Steps for 3 handle shower faucet replacement. shut off the water at the main water shutoff. put a drop cloth in the tub to protect it from any work and also to prevent small parts from falling down the drain. remove the handles from the valves using the screwdriver. they’re usually under small covers that read “hot” and “cold.”. Clean the valve body thoroughly, removing any debris or old sealant. apply a small amount of plumber’s grease to the o rings on the new cartridge. align the cartridge properly. the hot and cold sides should match the valve body. insert the new cartridge into the valve body, pressing firmly but gently. 2 pull the stop tube straight out, sliding it off of the cartridge. using a pair of pliers, pull the u shaped cartridge retainer clip off of the valve body. slide the small spacer washer off of the shaft and set it aside with the retainer clip. 3 a white plastic nut like tool should be packaged with the new cartridge. Rebuilding an old shower valve to like new condition with this old house plumbing and heating expert richard trethewey. (see below for a shopping list and to.
Comments are closed.